Handcraft type:
Category:
- First you need to draw a draft. Take a sheet of paper and bend it in half. We will draw on the folding line of paper. From the left side put a dot and measure from it 13 cm to the right and put a second dot. Draw a line 2 cm up from each dot. Connect the lines together. You will get a large rectangle.This is the body of our plane. Measure 4 cm from the left side in the middle of the plane body. Set the point and draw a line 2.5 cm to the right. This is the line where later we will insert the wings.
- From the top left edge of the plane draw a line up 4 cm. From its end draw a line 2 cm to the right and now connect it to the the plane body.
- From the top right edge of the airplane also draw a line 4 cm up. From its end 4 cm to the left and connect it to the plane body. Divide the 4 cm line in half and draw a line down to the side of the plane body. Later we will need to cut this line.
- Now take a small piece of paper. Bend it in half. Draw a horizontal line of 2.5 cm. On the right side draw a line 4 cm up. From its end measure 2 cm to the left. Connect the bottom and top lines diagonally. These are the wings of the airplane.
- Cut out all the details. And cut the wings along the fold line. So you'll have two identical details.
- Cut the line from the right side which we spoke earlier. And also carefully cut the line for the wings.
- Bend 0.5 cm of the wing bottom edge of the plane. Now you need to attach your wings into the cuts in the plane body and glue it.
- Fold inside the details from the left edge so that you get a sharp spout.
- And fold the details from the right side as shown on the picture.
- You can paint your plane and it's ready!